Permitting Authorities / City of Glendale Building & Permits Department

Do you need a permit to replace a roof in Glendale, CO?

Adopted code

City of Glendale Building & Permits Department

Yes — a permit is required to replace a roof in Glendale, CO, issued by City of Glendale Building & Permits Department. Building permit applications are required for all project types except signs, and permit fees are based on project valuation.

Jurisdiction
City of Glendale, Colorado
Jurisdiction type
city
Address
Glendale, CO
Contact
  • url: https://www.glendale.co.us/107/Building-Permits-Department
  • phone: 303-759-1513
Roofing permit required
Required
Contractor registration required
Required
Registration details
  • license: All contractors must be licensed with the city prior to pulling a permit. The city requires a copy of any state or ICC certifications as well as a current certificate of insurance; renewal is available to contractors licensed within the past two years.
Permit process note
Building permit applications are required for all project types except signs, and permit fees are based on project valuation.
Inspection requirements
Inspection requests must be submitted by 3:30 p.m. the day prior to the inspection.
Adopted code
Effective June 23, 2026, Glendale adopted the 2024 editions of the International Codes (including the IBC, IRC, IFC, IECC, IEBC, IFGC, IPC, IMC, ISPSC, and IPMC) plus the 2023 National Electrical Code and various NFPA standards.
Impact-resistant roofing
Not required — The City of Glendale's Ordinance No. 1, Series of 2026, adopted on second reading June 2, 2026 after introduction on May 5, 2026, was read in full. It repeals and re-enacts Chapters 15.04 and 15.08 of the Glendale Code of Ordinances and adopts by reference the 2024 editions of the International Building, Fire, Energy Conservation, Existing Building, Fuel Gas, Plumbing, Mechanical, Residential, Swimming Pool and Spa, and Property Maintenance Codes, the 2023 National Electrical Code, several National Fire Protection Association standards and the Colorado Conveyance Regulations, each as amended by the City's own enumerated amendment sections at 15.04.010 and following and 15.08.010 and following. Those amendments were read in full. The single roofing amendment is Section 15.04.041, which adds Building Code Section 1503.6 requiring that mechanical equipment placed or reset on roofing be supported on minimum eight-inch curbs, platforms or legs bearing on the decking and made watertight, with an exception for units weighing 400 pounds or less set on vibration isolation pads where the roof warranty permits. No amendment reaches the roof-covering sections of Chapter 15 of the Building Code or Chapter 9 of the Residential Code, and the only Residential Code amendment in the ordinance concerns a plumbing clearance. Neither the adopted codes nor any City amendment requires impact-resistant roof coverings or names a UL 2218 or Class 4 standard. The ordinance is effective for all permits applied for on or after June 23, 2026. The only statewide instrument reaching reroofing is the Colorado Wildfire Resiliency Code, 8 CCR 1507-39, effective July 1, 2026 in areas designated wildland- urban interface under that code, which requires a Class A roof covering tested to ASTM E108 or UL 790 where 25 percent or more of the roof surface is replaced, at Sections 101.6 and 403.2; that is a fire classification independent of impact rating, and the code sets no impact-resistance requirement.
Sales & use tax
8.00% combined (City of Glendale 3.75% + State of Colorado 2.90% + Cultural Tax (SCFD) 0.10% + Arapahoe County 0.25% + RTD Tax 1.00%). "The City of Glendale is a Home Rule City and collects its own sales tax." The City separately levies a 3.75% Use Tax (same rate as its sales tax) — "due when a legally imposed City sales tax has not been paid on the purchase, rental, or lease of tangible personal property that is stored, used, or consumed in the City of Glendale," including materials brought into the City from a lower-tax jurisdiction. No construction-permit- specific use-tax deposit mechanism was found; the City's "What is Use Tax?" guide describes only the general self-assessed business use tax process (reported on Line 8 of the City's Sales/Use Tax Return), not a building-permit deposit process.

The building permit authority for the City of Glendale, an enclave city in Arapahoe County. Requires building permit applications for all project types except signs, requires all contractors to be licensed with the city before pulling a permit, and adopted the 2024 I-Codes effective June 23, 2026.

Working an insurance claim in Glendale, CO? Everything on this page — drip edge, ice & water shield, inspections, Class 4 rules — formatted as a claim-ready evidence pack: verbatim ordinance quotes, code section cites, verification dates, and official source links, ready to attach to a supplement. See a real sample pack (PDF) — one page, free.

Buy this jurisdiction's pack — $12 Delivered by email within minutes.

Questions about the Glendale, CO pack?

Not ready to buy, or need a different jurisdiction? Tell us and we’ll reply directly.

By submitting, you agree to our Terms of Use and Privacy Policy.

Sources

Free instant roof estimate — Glendale, CO

Ballpark your replacement in 20 seconds. No phone call required to see the number.

Roofing questions — Glendale, CO

Do you need a permit to replace a roof in Glendale, CO?

Required.

Do roofing contractors need a license or registration in Glendale, CO?

Required. All contractors must be licensed with the city prior to pulling a permit. The city requires a copy of any state or ICC certifications as well as a current certificate of insurance; renewal is available to contractors licensed within the past two years..

What building code does Glendale, CO use?

Effective June 23, 2026, Glendale adopted the 2024 editions of the International Codes (including the IBC, IRC, IFC, IECC, IEBC, IFGC, IPC, IMC, ISPSC, and IPMC) plus the 2023 National Electrical Code and various NFPA standards.