Permitting Authorities / City of Federal Heights Building Department
Do you need a permit to replace a roof in Federal Heights, CO?
Adopted code
City of Federal Heights Building Department
Yes — a permit is required to replace a roof in Federal Heights, CO, issued by City of Federal Heights Building Department. A roofing permit is required any time more than one square (100 square feet) of roof covering is replaced. City roofing standards require each slope containing damaged shingles to be replaced in its entirety rather than patched.
Jurisdiction
City of Federal Heights, Colorado
Address
Federal Heights, CO
Contact
- url: https://www.fedheights.org/building
- phone: 303-412-3526
Roofing permit required
Required
Registration details
- license: The Building Department provides a Contractor's Registration Application and a Subcontractor License Form for contractors working in the city.
Permit process note
A roofing permit is required any time more than one square (100 square feet) of roof covering is replaced. City roofing standards require each slope containing damaged shingles to be replaced in its entirety rather than patched.
Inspection requirements
Inspections are arranged by emailing
[email protected] or calling 303-412-3534 before 3:30 p.m. on the preceding day. The State of Colorado Department of Regulatory Agencies administers all electrical permits and inspections.
Adopted code
Federal Heights adopted the 2021 ICC codes (including the 2021 IBC and 2021 IRC) via Ordinance 23-02 on March 7, 2023, effective April 15, 2023 based on permit application date, with the International Energy Conservation Code remaining at the 2018 edition.
Ice & water shield
Not required — Ice and water shield is not required unless specified per the manufacturer's installation instructions. This is the city's own adopted determination rather than an Adams County one: Ordinance No. 23-02, which adopts Federal Heights's technical codes, states that "Table R301.2 is repealed and reenacted to provide" a replacement table whose "Ice Shield Underlayment Requirement" reads "No" (alongside Ground Snow Load 40 lbs. per square foot, Seismic Design Category B, Weathering Severe, Frost Line Depth 36 Inches, Air Freezing Index 712, Mean Annual Temp 50.3F). Neighbouring Adams County jurisdictions reach the opposite conclusion, so this answer does not travel across the city boundary.
About ice & water barrier
Mid-roof inspection
Required — Mid-Roof Inspection required: all existing roof removed, 25% to 75% of new roof covering installed.
Impact-resistant roofing
Not required — Federal Heights's technical-code adopting ordinance (Ordinance No. 23-02, adopted March 7, 2023 and effective April 15, 2023, adopting the 2021 IBC and 2021 IRC) was reviewed in full, including all of its IBC and IRC amendment lists, as was the Building Department's Roofing Standards handout. The City's roofing provisions address shingle fastening (IBC 1507.2.6, not less than four fasteners per strip shingle, and six between September 15 and April 15) and the extent of slope replacement on reroofs (IBC 1512.1.1); the City makes no amendment to IRC R905.2.4. Neither instrument contains an impact-resistance, UL 2218, or Class 4 requirement. The handout's approved asphalt shingle list qualifies products on warranty term and a national wind warranty for 80 mph sustained or 90 mph 3-second gust, not on impact rating.
Repair permit threshold
Replacement of less than one square (100 sq. ft.) of roof covering is considered a repair and does not require a permit; more than one square requires a building permit, and each slope containing damaged shingles must be replaced in its entirety.
Wind design criteria
Table R301.2 as repealed and reenacted (Ordinance 23-02, adopting the 2021 IRC, adopted 2023-03-07, effective 2023-04-15): "Wind Design: Speed: 90 mph, 3 second gust or ultimate of 115 m.p.h. Category: II. Exposure: B. Topographic Effects: No." Seismic Design Category B, Ground snow load 40 psf, Ice Shield Underlayment Requirement: No. The ordinance's table does not include separate special-wind-region or windborne-debris-zone rows.
Deck & sheathing requirements
Maximum spacing for existing sheathing is ¼ inch.
Fastening requirements
City roofing standards require that materials and fastening methods be rated for 115 mph wind. No fastener count is stated, so the IRC R905.2.6 floor of four per strip shingle applies, with the shingle manufacturer's installation instructions governing above it.
About roofing nails
Sales & use tax
8.75% combined (state 2.9% + Adams County 0.75% + RTD 1% + SCFD 0.1% + city 4%); home-rule, self-collected. City use tax of 4% applies to construction materials, calculated through the building permit process on an estimated materials cost (minimum 50% of project valuation).
Local roofing hub
Roof permits nearby — Adams County
Related guides
The building permit authority for the City of Federal Heights, a home-rule city in Adams County that runs its own building department. Requires a roofing permit when more than one square of roof covering is replaced and has adopted the 2021 ICC codes.
Working an insurance claim in Federal Heights, CO? Everything on this page — drip edge, ice & water shield, inspections, Class 4 rules — formatted as a claim-ready evidence pack: verbatim ordinance quotes, code section cites, verification dates, and official source links, ready to attach to a supplement. See a real sample pack (PDF) — one page, free.
Buy this jurisdiction's pack — $12 Delivered by email within minutes.
Questions about the Federal Heights, CO pack?
Not ready to buy, or need a different jurisdiction? Tell us and we’ll reply directly.