The Roofing Book

Permitting Authorities / Texas / City of Greenville - Building Permits and Inspections

Do you need a permit to replace a roof in Greenville, TX?

Adopted code

City of Greenville - Building Permits and Inspections

Yes, a permit is required to replace a roof in Greenville, TX, issued by City of Greenville - Building Permits and Inspections. The City's Roofing Guide states "Permit Fee: Flat fee of $50.00," that the "Permit must be posted and clearly visible from street," and that the inspection is "Building Final only unless otherwise noted on the Building Permit," covering shingles and flashing installed per the manufacturer, plumbing and gas vents re-attached and flashed correctly, and debris hauled away. The packet says applications are submitted by email to the Building Permits and Inspections office.

Roof code checklist: Greenville, TX

ItemAnswerCode citeSourceVerified
Permit to replace a roofYesgreenvilletx.gov2026-10-20
Repair permit thresholdPublishedgreenvilletx.gov2026-10-20
Layer limit / roof-overPublishedgreenvilletx.gov2026-10-20
Deck & sheathingNot published
Drip edgeYesgreenvilletx.gov2026-10-20
Ice & water shieldNot published
Mid-roof inspectionNot published
Impact-resistant (Class 4) roofingNot published
Wind design criteriaNot published
Adopted codePublishedSec. 214.212(a)greenvilletx.gov2026-10-20
Contractor license / registrationNot published
Sales & use taxPublishedcomptroller.texas.gov2026-10-06

Each row comes from the sourced record on this page; full wording is in the table below. "Not published" means no official source for that item was found when the record was last verified.

Jurisdiction
City of Greenville, Texas
Jurisdiction type
city
Address
2315 Johnson St, Greenville, TX 75402
Contact
  • url: https://www.greenvilletx.gov/420/Permits-Inspections
  • phone: 903-457-3160
Roofing permit required
Required
Permit process note
The City's Roofing Guide states "Permit Fee: Flat fee of $50.00," that the "Permit must be posted and clearly visible from street," and that the inspection is "Building Final only unless otherwise noted on the Building Permit," covering shingles and flashing installed per the manufacturer, plumbing and gas vents re-attached and flashed correctly, and debris hauled away. The packet says applications are submitted by email to the Building Permits and Inspections office.
Adopted code
The City of Greenville's Permits & Inspections page states: "All construction work must conform to the requirements of the codes adopted by the City of Greenville," and lists "2018 International Building Codes," including the International Residential Code for One- and Two-Family Dwellings (IRC), the 2017 National Electric Code and the 2018 IECC. The page also says it is the contractor's responsibility to know "all local code amendments adopted by the City," which this record did not read, so it does not state whether the City has amended the IRC's roof provisions beyond the Roofing Guide's own statements. Texas Local Government Code section 214.212(a) provides that "the International Residential Code, as it existed on May 1, 2012, is adopted as a municipal residential building code in this state," and a city may adopt local amendments by ordinance after a public hearing.
Drip edge
Required — The City's Roofing Guide states: "Drip Edge is required on all asphalt shingled roofing projects." This rests on the department's written guide, effective August 1, 2022; the enacted amendment text was not read. About drip edge
Repair permit threshold
The City's Roofing Guide in its Re-Roofing Permit Packet, effective August 1, 2022, states: "Permits are required for all roofing projects and the work shall comply with the 2018 IRC." The same guide states: "Shingle replacement does not require a permit." The guide does not define the line between the two statements.
Roof layer limit / recover
The City's Roofing Guide states that new roof coverings shall not be installed without first removing all existing layers "Where the existing roof has two or more applications of any type of roof covering," and also where the existing roof or covering is water-soaked or deteriorated, or is wood shake, slate, clay, cement or asbestos-cement tile. It lists exceptions for complete and separate roofing systems such as standing-seam metal, for protective coating over spray polyurethane foam, and for an existing adhered ice barrier membrane.
Sales & use tax
8.25% combined (6.25% state + 1.5% Greenville + 0.5% county) on the Texas Comptroller of Public Accounts city sales and use tax rate sheet for July 2026. Under Comptroller guidance for real property repair and remodeling, "Labor to repair, remodel, or restore residential real property is not taxable"; on the lump-sum contract typical of residential re-roofing, "you pay tax on all your supplies, materials, equipment, and taxable services when you buy them. You don't charge your customer tax" (Comptroller Pub. 94-116, Real Property Repair and Remodeling), so the combined rate above is the roofer's own cost basis on materials purchased, not a rate charged to the homeowner.

Local roofing hub

Roofing in Greenville, TexasCity hub

More roof permit pages in Texas

Groves, TXRoof permit Haltom City, TXRoof permit Harker Heights, TXRoof permit Harlingen, TXRoof permit Hereford, TXRoof permit Roofing in TexasState hub

Related guides

DFW Permits City-by-City Hail-Belt Rules by State Denver-Metro Roofing Permits Filing a Hail Insurance Claim Colorado Hail Season Prep Hiring a Contractor

The Permits and Inspections Division of the City of Greenville's Community Development department receives building permit applications and performs inspections for construction on private property in the City, in Hunt County, Texas. Texas has no statewide roofing contractor licence, and a city sets its own roofing rules by ordinance, so Greenville's rules are its own. The City's page says it has adopted the 2018 International Building Codes, including the International Residential Code, and its Re-Roofing Permit Packet sets a flat $50.00 permit fee and requires drip edge on asphalt shingle roofing projects. This listing covers the office's contact details, the City's own statements on code and permits, and the statewide rules.

Working an insurance claim in Greenville, TX? Everything on this page (drip edge, ice & water shield, inspections, Class 4 rules) formatted as a claim-ready evidence pack: verbatim ordinance quotes, code section cites, verification dates, and official source links, ready to attach to a supplement. See a real sample pack (PDF, 4 pages, free).

Code items like drip edge are what adjusters ask you to document.

Buy this jurisdiction's pack: $12 Delivered by email within minutes. Digital download: all sales are final once delivered, except for a failed delivery, a defective file, a duplicate purchase, or a pack materially different from its description. See Section 6 of our Terms of Use.

Questions about the Greenville, TX pack?

Not ready to buy, or need a different jurisdiction? Tell us and we’ll reply directly.

By submitting, you agree to our Terms of Use and Privacy Policy.

Sources

Roofing questions: Greenville, TX

Do you need a permit to replace a roof in Greenville, TX?

Yes, a permit is required to replace a roof in Greenville, TX. The City's Roofing Guide in its Re-Roofing Permit Packet, effective August 1, 2022, states: "Permits are required for all roofing projects and the work shall comply with the 2018 IRC." The same guide states: "Shingle replacement does not require a permit." The guide does not define the line between the two statements.

Is drip edge required in Greenville, TX?

Yes. The City's Roofing Guide states: "Drip Edge is required on all asphalt shingled roofing projects." This rests on the department's written guide, effective August 1, 2022; the enacted amendment text was not read.

Can you roof over an existing roof in Greenville, TX?

The City's Roofing Guide states that new roof coverings shall not be installed without first removing all existing layers "Where the existing roof has two or more applications of any type of roof covering," and also where the existing roof or covering is water-soaked or deteriorated, or is wood shake, slate, clay, cement or asbestos-cement tile. It lists exceptions for complete and separate roofing systems such as standing-seam metal, for protective coating over spray polyurethane foam, and for an existing adhered ice barrier membrane.

What building code does Greenville, TX use?

The City of Greenville's Permits & Inspections page states: "All construction work must conform to the requirements of the codes adopted by the City of Greenville," and lists "2018 International Building Codes," including the International Residential Code for One- and Two-Family Dwellings (IRC), the 2017 National Electric Code and the 2018 IECC. The page also says it is the contractor's responsibility to know "all local code amendments adopted by the City," which this record did not read, so it does not state whether the City has amended the IRC's roof provisions beyond the Roofing Guide's own statements. Texas Local Government Code section 214.212(a) provides that "the International Residential Code, as it existed on May 1, 2012, is adopted as a municipal residential building code in this state," and a city may adopt local amendments by ordinance after a public hearing.